Glascoed Mill

Ground floor is divided into two unequal bays, the larger northern bay a workshop with continuous bench against the E wall set over a horizontal layshaft. Small portable belt-driven grindstone. The narrow S bay, originally for the pit wheel, is divided off with a timber partition, and has an irregular floor 6 steps lower, and contains the two long vertical iron drive shafts for belts to engage the new (in 1923) elongated stone spindles, one with a belt pulley with curved radial arms, supported off the original wooden axle tree re-used as a floor beam. From the workshop, a dog-leg stair leads up to the stone floor with two pairs of underdrift French stones in their original octagonal vats, and complete with horses, hoppers, slippers, and quants with damsels. An ancillary horizontal drive, geared down 50% with bevel gear over the stones probably drove the wire dressing machine which is still in place in the N corner. Ladder steps to second floor which has the sack hoist pulley and drum, operated by extant chain and rope from the workshop floor via floor traps.

The lower extension building has a fireplace in the gable wall of the main block, with an iron range, and a large spoked belt drive at the end of the main horizontal drive against the E wall. The belt apparently drove the remaining ball and planets governor.

Limewashed rubble stonework, with slate roof, hipped at S end. Three storeys, with added lower bay at N end with door and window, and former wheel pit at S end in a timber weatherboarded structure now with a corrugated iron roof.

Of 2 bays, Ground, first (stone) and attic(hoist) floors. On the ground floor stable door and a loading door to the stone floor. Two light windows with segmental heads. Various iron tie bars with iron felloes forming end restraints. Chimney at N end, partially reduced in height. Building extended back from river with a lower 2-storey stone structure with door and window to upper floor. Immediately SW of the mill, the main water entry flume has two sets of cog operated paddles and sluices.

The external waterwheel was apparently removed in 1923, and partially filled. The low section contains a vertical shaft with a large horizontal iron turbine at low level and a spoked belt pulley at the top, connected by belt, turned by an idler through 45 degrees to engage the main horizontal mill drive. The turbine wheel itself has, above the multiple cupped blades, a chainlink control mechanism engaged by an escapement rocker on a vertical shaft, geared to a horizontal shaft passing diagonally across at high level to an auxiliary oil engine.